Saeco IDEA RST Technical Manual page 32

English
3...180
1.12.3 Water quantity
27...2702
1.12.4 Grinder 1 setting
40...500
1.12.5 Grinder 2 setting
40...500
1.12.6 Grinder selection
Left
Right
User
1.12.7 Mixing Water %
10...100
1.13 HOT WATER
1.13.1 Water quantity
24...2487
1.13.2 Max. nbr.
0...8
1.14 Power Steam
20...100
2 TEMPERATURES SETUP
2.1 Low
70...120
2.2 High
70...120
2.3 1st coffee
70...120
2.4 Parameter K1
1...50
2.5 Parameter K2
1...120
2.6 BU pre-heating
2.6.1 Warming delay
0...99
2.6.2 Warming dose
0...99
2.6.3 Warming time
0...99
3 PUMPS SETUP
3.1 Single cup
1P
2P
3.2 Double cup
1P
2P
4 PREBREWING SETUP
4.1 Prebrewing sec.
0,4...3
4.2 Pause sec.
1...4
5 MILK PROGRAMMING
5.1 Drainage sec.
32
Default:
60
Default:
60
Default:
60
Default:
100%
The "HOT WATER" option sets the amount dispensed, by pressing the "Hot water" button.
If the above mentioned function is disabled, dispensing must be interrupted by pressing the button again.
Default:
135
By setting 0, the product is dispensed without having to confirm with the OK button.
Default:
8
(only AutoSteam model)
LOW is the temperature value to which the coffee boiler is set during the continued coffee brewing.
Default:
80
HIGH is the temperature value that the coffee boiler reaches after a period of inactivity (approx. 10 minutes)
Default:
86
1ST COFFEE is the temperature value that the coffee boiler reaches when turning on the appliance
Default:
92
Factory default value, must not be changed
Default:
7
Factory default value, must not be changed
Default:
30
The "SINGLE CUP" option enables 1 or 2 pump(s) to brew the single doses.
(default 2P)
The "DOUBLE CUP" option enables 2 pumps (2P) or a single pump (1P) to brew the double dose.
(default 2P)
The "PREBREWING" option shows the amount of time necessary to open the coffee solenoid valve to soak the coffee tablet.
The time can be set ranging from 0. 4 to 3 sec.
Default:
2 sec
The "PAUSE" option shows the stop brewing time.
The time can be set ranging from 1 to 4 sec.
Default:
2 sec
The "DRAINAGE" option shows the amount of time necessary to open the solenoid valve that drains the condensed water in the
tube, which allows the steam to reach the Cappuccinatore.
It can be set from 0 to 8 seconds.