Saeco IDEA RST Technical Manual page 41

The testing procedures are summed up in the following table, where the tests for each menu page are shown after pressing the A, B, C and D
buttons.
Menu Page A button
The gearmotor of the group is
M1
turned on until it reaches the W
brewing position.
(*)
M2 The HOT WATER and STEAM
BOILER RE2 heating element is
powered
M3 PC1+PC2+EVI
Coffee pumps + Inlet solenoid
valve
M4 PA3+PA4+EVI
Water pumps + Inlet solenoid
valve
M5 EV10
Drain solenoid valve
M6
(*) :
As regards the DUO model, first select the grinder to be checked and then enter the Test Menu
B button C button
The gearmotor of the group is The Red LED light is
turned on until it reaches the N switched on in the
off position. CPU/IO board
The HOT WATER and STEAM The COFFEE BOILER RC
BOILER RE1 heating element is heating element is
powered powered
PC1+PC2+EV1+EVC PC1+PC2+EV1+EVM
Coffee pumps + Inlet solenoid Coffee pumps + Inlet
valve + Coffee solenoid valve solenoid valve + Mix
water solenoid valve
PA3+PA4+EVI+EVL PA3+PA4+EVI+EVA
Water pumps + Inlet solenoid Water pumps + Inlet
valve + Level solenoid valve solenoid valve + Water
solenoid valve
EV8 EV8
Clamp solenoid valve Steam solenoid valve
Automatic steam wand solenoid valve Electromechanical pulse counters
D button
The coffee grinder motor is turned on and the number of
coffee grinder turns are displayed in the lower line on the
bottom right.
The CUP WARMING SURFACE PS heating element is
powered
PC1+PC2+EV1+EVM+EVC
Coffee pumps + Inlet solenoid valve + Mix water solenoid
valve + Coffee solenoid valve
Turns the coffee grinder counter-clockwise.
If the grinders are blocked, the coffee grinder can sometimes
be released.
(*)
Cold water solenoid valve + Inlet solenoid valve
Left and Right Led alternated (model DUO)
English
41