Symbol Definitions - Extron electronics DTP2 T 212 User Manual

Symbol Definitions

]
}
•
E
X!
X@
X#
X$
X%
X^
X&
X(
X1)
X1!
X1@
X1#
X1$
X1%
X1&
= CR/LF (carriage return with line feed) (hex
|
or = Soft carriage return (no line feed)
= Space
W
or = Escape
= Input number 0 to 2 (for switching)
0 = Deselect input (break tie) resulting in output disabled
= On and off, enabled or disabled, detected or not detected
0 = Off, disabled, or not detected
1 = On, enabled, or detected
= Auto switch mode
0 = Disabled
1 = Enabled, highest active input has priority (default)
2 = Enabled, lowest active input has priority
= Video color bit depth mode
1 = Automatically based on sink EDID (default)
2 = Force 8-bit
= Input HDCP status
0 = No video detected
1 = Video detected with HDCP
2 = Video detected without HDCP
= Output HDCP status
0 = No sink detected
1 = Sink detected with HDCP
2 = Sink detected without HDCP
= Switcher name
The name can have up to 24 alphanumeric characters including hyphens (-), with no
spaces. The first character must be a letter, and the last character cannot be a hyphen.
The default is DTP2-T-212.
= Verbose mode
0 = Clear/none
1 = Verbose mode (default)
2 = Tagged responses for queries
3 = Verbose mode and tagged responses for queries
= TMDS output format
1 = Auto, pass through if HDMI sink, force DVI format if DVI sink (default)
2 = DVI RGB 444
3 = HDMI RGB "Full"
4 = HDMI RGB "Limited"
5 = HDMI YUV 444 "Limited"
6 = HDMI YUV 422 "Limited"
EDID memory location
=
1 to 4 = See the
EDID Table
= Current EDID information in hexadecimal format (128 or 256 bytes of hex data)
= Native resolution and refresh rate from selected EDID (example: 1920x1200 @ 60 Hz)
= Tally pin mode on channel mute
0 = Always on (default)
1 = Off when muted
2 = Blink when muted
= DTP/HDBT switch position
0 = DTP (default)
1 = HDBT
= Permanent tie mode
0 = Disable
1 = Output 1 tied to input 1
2 = Output 1 tied to input 2
0D 0A
)
on page 19.
DTP2 T 212 • SIS Commands 39