Table of Contents
Advertisement
Permanent Tie to ( see
6
tie of one of the inputs to the HDMI output. Select Disabled, Input 1, or Input 2.
The HDMI output only outputs the input tied to it, regardless of which input is manually
selected.
Video Mute and Sync Mute — Select one or both of these buttons to mute the video,
7
sync or both on an individual output.
Mute Embedded Audio — Select this button to mute the audio embedded in the
8
HDMI output signal.
DTP/HDBT Status — Displays DTP or HDBT to indicate whether the receiver connected
9
to the DTP/HDBT output is an Extron receiver or an HDBase-T enabled receiver, based
on the position of the DTP/HDBT toggle switch.
Remote Power Status — Displays Send Power or No Remote Power to indicate
¢
whether the transmitter is sending power to the far end receiver, based on the position
of the remote power toggle switch.
5V Mode — Disable or enable 5V Hot-Plug:
£
•
Auto — 5 V is enabled when a source with 5 V is present, otherwise it is off.
Enabled — 5 V is always on.
•
EDID Minder
EDID Minder is a process that manages the EDID information (resolution and refresh rate)
between the DTP2 T 212 HDMI inputs and one or more output sources. Click the EDID
Minder icon (see figure 17,
page. EDID can be set to match output rate, a custom user-defined EDID, or a factory
setting.
Figure 17.
figure 16
on page 25)— Disable or enable a permanent
) on the global navigation bar to open the EDID Minder
1
EDID Minder Page
DTP2 T 212 • Configuration Software
26
Advertisement
Table of Contents
