Cycle Parts
REMOVING THE FRONT MUDGUARD
Read through the section PRECAUTIONS AND
GENERAL INFORMATION.
Place the vehicle on the stand.
Loosen and remove the four screws (1).
Tightening torque for screws (1):
7 Nm (0.7 kgm) [5.2 ft-lb]
Collect the related self-locking nuts (2).
Loosen and remove the two screws (3) (left and right
sides).
Tightening torque for screws (3):
5 Nm (0.5 kgm) [3.7 ft-lb]
WARNING
When handling plastic and painted parts, take
care not to score or damage them.
Remove mudguard (4) from the front.
REMOVING THE FRONT TURN INDICA-
TORS
Read through the section PRECAUTIONS AND
GENERAL INFORMATION.
Place the vehicle on the stand.
Turn the ignition switch to " " .
Remove the side fairings (REMOVING THE SIDE
FAIRINGS).
Loosen and remove screw (5) (left and right sides).
Collect the related nuts on the other side.
Remove turn indicator (6).
WARNING
When removing turn indicator (6), help the electri-
cal wire with the related connector through the
slot in the fairing.
chap. 7
4
Release 00
2000-11
RS 50
1
2
3
5
6
7-19
7