Changing The Fuse - APRILIA RS 50 Workshop Manual

Electrical Equipment
NOTE
Insert the bulb in the bulb socket, making the
two bulb pins coincide with the relevant guides on the
socket.
Correctly install a new bulb (7) of the same type.
ADJUSTING THE VERTICAL
HEADLIGHT BEAM
To rapidly check the correct direction of the beam,
place the vehicle on flat ground, 10 m away from a
wall.
Turn on the low beam, sit on the vehicle and make
sure that the beam projected on the wall is slightly
under the horizontal line of the headlight (about 9/10th
of the total height).
To adjust the headlight beam:
Working on the rear left side of the front part of the
fairing, adjust the appropriate screw (1) by means of a
short crosstip screw driver.
By SCREWING IT (clockwise), you set the beam
upwards.
By UNSCREWING IT (anticlockwise), you set the
beam downwards.

CHANGING THE FUSE

Carefully read the PERIODIC MAINTENANCE
SCHEDULE.
CAUTION
Do not repair faulty fuses.
Never use fuses different from the recommended
ones.
The use of unsuitable fuses may cause damages
to the electric system or, in case of short circuit,
even a fire.
NOTE
If a fuse blows frequently, there probably is a
short circuit or an overload in the electric system.
chap. 6
Release 00 2000-11
RS 50
7
6
1
6-27