Changing A Fuse - APRILIA SCARABEO 50 2T - 2005 Manual

u Coat the terminals of cables and battery
with special grease or Vaseline.
CAUTION
When reassembling bring electric
c a b le s i n t h e i r p o s i t i o n c a r e f ul l y
avoiding any crushing.
Negative cable (–) shall not be placed
over positive cable (+) fastening but
near it between battery and box.
Push the battery inside the battery box.
u
u Close the battery cover (1).
504T 1004T
u Lower the seat, see page 18
504T
1004T
(UNLOCKING/LOCKING THE SEAT).
u Position the fuse carrier frame (3).
50 2T 50 2T
u Tighten the screw (2).
50 2T 50 2T
u Refit the inspection cover, see
50 2T 50 2T
p a g e 5 3 ( R E M O V I N G
INSPECTION COVER).
62 use and maintenance Scarabeo 50 2T - Scarabeo 50 4T - Scarabeo 100 4T

CHANGING A FUSE

C a r e f u l l y
(MAINTENANCE).
F R O N T
Do not repair faulty fuses.
Never use a fuse of a rating other than
specified.
This could damage the electric system
or cause a short circuit, with the risk of
fire.
NOTE
When a fuse fitted in a particular
position keeps blowing frequently, there
might be a short circuit or overloading. In
this case, contact an aprilia Authorised
Dealer.
r e a d p a g e 4 0
CAUTION
50 2T
1
3
Checking the fuse (1) is recommended
whenever an electric component fails to
operate or is malfunctioning, or when the
engine does not start.
Check as follows:
u Set the ignition switch to " " to avoid
any short-circuit.
u Remove the inspection cover, see
page 60 (REACHING THE BATTERY).
u Extract and check the fuse (1) - a broken
filament (2) means that the fuse is
blown.
u Before replacing a fuse, identify the
cause of the failure, if possible.
Then replace the damaged fuse with the
u
outfit spare fuse (3) or with one of the
same amperage.