Process-Related Faults And Messages - Miele PG 8583 CD Operating Instructions Manual

Frequently asked questions
Problem
Fault 578

Process-related faults and messages

Problem
Insert a new coarse filter
Change HEPA filter
Drying during program deacti-
vated
Wrong code entered
Test program: Test object
can now be removed
Program cancelled
142
Possible cause and solution
The peak-load cut-out has lasted longer than 3 hours.
Have your electrical system and your energy manage-

ment system tested by a suitably qualified person.
Possible cause and solution
The maximum permitted operating hours for the coarse fil-
ter have been reached.
Replace the coarse filter with a new one.

Reset the operating hours counter for the coarse filter.

The maximum permitted operating hours for the HEPA filter
have been reached.
Replace the HEPA filter with a new one.

Reset the operating hours counter for the HEPA filter.

Drying cannot be selected at the start of a program be-
cause drying is not available for the selected program.
Start the program without drying.

Or
Have the drying parameters for this program adjusted by

Miele Service.
The PIN code entered is not the same as the code saved.
Enter the PIN code again.

Report the loss of the PIN code to Miele Service.

This is not a fault.
A test program is running to check performance. At certain
points in the program, the sequence is interrupted so that
samples can be taken.
Take a sample.

or
Wait. The program will continue automatically in approx.

30 seconds.
or
Continue the program without delay by pressing the

Start/Stop button.
This is not a fault.
A program which was running was canceled by the user.
 The wash cabinet interior can be very hot.
When the door is opened, hot steam and process chemi-
cals can escape. Protective measures for personal safety
must be observed.