Table of Contents
Advertisement
1-5-3. VF Connector
c
When opening the side panel during or immediately after use of the unit, be careful as the board panel is
very hot and touching it may result in burns. When opening the side panel to perform inspections and
adjustments, turn off the power and wait 10 minutes for the unit to cool down first.
n
Refer to Section 1-8 for details on disconnecting/connecting the flexible card wire.
1. Remove the board bracket. (Refer to steps 1 to 5 of Section 1-5-2.)
2. Remove the two screws (Precision P2.6 x 10) and pull out the VF connector with harness.
VF connector
Precision
P2.6 x 10
3. Install a new VF connector in the reverse order of removal.
BVP-9500WS/9500WSP MM
1-5. Replacing External Connectors
1-23 (E)
Advertisement
Table of Contents
