Cleaning Of The Evf; Removing The Vf Lens Tube Assy - Sony DSC-HX90 Service Manual

2-4.

Cleaning of the EVF

This unit makes it possible to disassemble the EVF from the finished state to clean it. When a problem related to dust
is indicated from a customer, remove the VF Lens Tube Assy in the following procedure and clean it.
When cleaning the VF Lens Tube Assy, use birdlime or the like to remove dust.
• Recommended jig: J-6082-726-A Cleaning Stick II
Note
• Carry out the cleaning work in a clean environment to avoid dust or foreign matter during disassembling.
Use a clean booth if possible.
• Do not use an air blower because it raises surrounding dust.
• Do not use cleaning cloth that causes wiping unevenness.
2-4-1.

Removing the VF Lens Tube Assy

Preparation:
Make a jig as shown below by bending fine wire.
Approx. 5 mm
Approx. 30 mm
Procedure:
1. Depress the viewfinder pop-up switch to pop up the EVF.
2. Draw the VF Lens Tube Assy.
Holes
Viewfinder
pop-up switch
DSC-HX90/DSC-HX90V
Approx. 0.7 mm
2-6