Replacing Vtr Start/Stop Switch (Sw-1336 Board); Replacing Lock, Vf Menu/Display, And; (Cn-2997 Board); Replacing Assignable Switch (Sw-1332 Board) - Sony F35 Maintenance Manual
Digital cinematography camera
Hide thumbs
Also See for F35:
- Operation manual (150 pages) ,
- User manual (26 pages) ,
- Brochure & specs (20 pages)
Table of Contents
Advertisement
2-4-3. Replacing VTR Start/Stop Switch (SW-
1336 Board)
1. Remove the inside panel. (Refer to Section 1-4.)
2. Remove the two screws, and remove the SW-1336
board.
3. Disconnect the red side of the harness (ASSIGN) from
the connector (CN1) on the SW-1336 board.
Screws
(M2.6)
4. Install the VTR start/stop switch (SW-1336 board) by
reversing the steps above.
2-4-4. Replacing LOCK, VF MENU/DISPLAY,
and CANCEL/STATUS Switches (CN-
2997 Board)
1. Remove the inside panel. (Refer to Section 1-4.)
2. Remove the two screws, and remove the CN-2997
board. Be careful not to lose the switch knob (A), drop
protection (SW), or lock sheet that are attached to the
LOCK switch S3.
3. Disconnect the harness (MENU) from the connector
(CN1) on the CN-2997 board.
Harness
(MENU)
Screws
(M2.6)
CN-2997board Switch knob (A)
4. Install the LOCK, VF MENU/DISPLAY, and CAN-
CEL/STATUS switches (CN-2997 board) by reversing
the steps above.
2-10
SW-1336 board
Harness (ASSIGN)
Lock sheet
Drop protection (SW)
2-4-5. Replacing ASSIGNABLE Switch (SW-
1332 Board)
1. Remove the inside panel. (Refer to Section 1-4.)
2. Remove the two screws, and remove the SW-1332
board.
3. Disconnect the gray side of the harness (ASSIGN)
from the connector (CN2) on the SW-1332 board.
Harness
(ASSIGN)
Screws
(M2.6)
SW-1332 board
4. Install the ASSIGNABLE switch (SW-1332 board) by
reversing the steps above.
2-4-6. Replacing MODE SET Switch (SW-
1333 Board)
1. Remove the inside panel. (Refer to Section 1-4.)
2. Remove the two screws, and remove the SW-1333
board, switch cushion, electrostatic spring, and PW
blind sheet.
3. Disconnect the harness (MENU) from the connector
(CN1) on the SW-1333 board.
Harness
(MENU)
SW-1333 board
Screws
(M2.6)
PW blind sheet
4. Install the MODE SET switch (SW-1333 board) by
reversing the steps above.
n
Tighten the screws at a position where the tip of the
toggle switch on the SW-1333 board comes to the center
of the rectangular toggle switch hole in the inside panel.
Switch
cushion
Electrostatic spring
F35
Advertisement
Table of Contents
