Changing The Schedule Default Value And Adding Events - Trane Tracer UC600 Installation, Operation And Maintenance Manual

Changing the Schedule Default Value and Adding Events

After creating a schedule and selecting the members, the next step is to determine the schedule
default value and add weekly events. An event is defined as a time-value pair.
About the Schedule Default Value
•
•
•
•
Changing the Schedule Default Value
1. Open the schedule that in which you want to make changes.
2. From the Default Value drop-down list select a different value.
3. Click Go. The new value is applied to the schedule.
Figure 33. Changing the schedule default value
BAS-SVX45F-GB
The default value is the relinquish default value of the first specified member. However,
changing this value affects only the schedule. It does not affect the Relinquish Default value
specified in that member's point configuration.
The default value can be changed. (Changing the default value does not affect the actual
configured default value of the point.)
The default value goes into effect each day at 12:00:00 a.m, provided that no other event takes
control at that time. It remains in effect until the first event occurs.
If the schedule members are multistate points, the states of the first selected member are used
for all members. You can select a default value from these states from the drop-down list.
When a schedule is created, the only event in the schedule is the schedule default value. This
value occurs every day at midnight and cannot be removed. If the schedule default value is
edited, the value applies to each day in the schedule.
Configuring Tracer UC600 with Tracer TU
57