Establishing A Network Connection With Tracer Tu; Configuring Ip Information - Trane Tracer UC600 Installation, Operation And Maintenance Manual

Establishing a Network Connection with Tracer TU

The following procedure describes how to establish a BACnet/IP network connection with Tracer
UC600. IP and BACnet configuration tasks must be performed prior to this procedure.
To establish a network connection:
1. In the Startup Panel dialog box, select the Network Connection radio button.
2. From Facility drop-down list (inside the Connect to frame), select IP Ethernet 1 network.
Figure 44. Establishing a network connection

Configuring IP Information

1. Navigate to Utilities > Status > Controller Settings. The Controller Settings utility opens.
2. Click Protocol to display a list of protocols that Tracer UC600 uses to communicate with other
3. Configure the Tracer UC600 with either a specified static IP address or, if necessary, configure
4. In the Security frame, select whether to enable HTTP communications (port 80) for remote
5. Click Send to Device.
6. Proceed to the
BAS-SVX45F-GB
Note: If you need to add a facility, see
controllers.
it to automatically acquire its IP address from the network's Dynamic Host Configuration
Protocol (DHCP) server. A hostname can be assigned to the device if a dynamic address is being
used (See Figure 45, p.
communication. (See "Security, " p. 81
Note: At this time the Tracer TD7 display option is not available when connecting with the
BACnet/IP protocol. This option will be available in a future Tracer UC600 firmware
upgrade.
"Configuring BACnet Information, " p.
Appendix A: Configuring Tracer UC600 for BACnet/IP
"Connecting Using Tracer SC, " p.
80).
for more information).
42.
80.
79