Omron Sysmac NY Series Hardware User Manual page 149

when wiring, either use separate cables or separate wiring routes for these items. Future mainte-
nance operations and changes to the system will also be made easier by carefully organizing the
wiring from the start.
• Power lines and signal lines
• Input signals and output signals
• Analog signals and digital signals
• High-level signals and low-level signals
• Communications lines and power lines
• DC signals and AC signals
• High-frequency devices (such as Inverters) and signal lines (communications)
l (Routing of) Wiring
Observe the following points when wiring power supply and signal cables.
• When routing signal cables with differing characteristics through the same duct, always keep
them separated.
• As much as possible, avoid routing multiple power supply lines through the same duct. If it can-
not be avoided, then construct a partition between them in the duct and ground the partition.
Signal
cables
(group A)
Signal cables
Power supply cables
Partitioning Methods for Signal and Power Supply Cables
• To avoid overheating the conduits when using conduits for wiring, do not place wires for a single
circuit in separate conduits.
Power supply
• Power cables and signal cables adversely affect each other. Do not wire them in parallel.
NY-series Industrial Box PC Machine Controller Hardware User's Manual (W556)
Signal Signal
cables cables
(group B) (group C)
Signal cables
(a)
(c)
NG
Conduits
Load
Incorrect
Parallel Wiring (Single Phase)
Partition
a
(b)
Signal cables
Power supply cables
(d)
Power supply
Power supply
5 Installation
Conduits
OK
Load
Correct
Conduits
OK
Load
Correct
5
5-23