Table of Contents
Advertisement
b) Unplug air hose on flush valve side from air hose
connector and pull it out from the mask.
b)
Note: This mask assembly needs to be purchased
separately. Part number: 1288193.
C. Installation of P-trap
C.
1. Insert drainage pipe with inner diameter
drain elbow and weld.
1.
2. Tighten the long screw into the holes of the tank bracket
and cover the drainage hole with the big cap, cover the
inlet hole with the small cap.
2.
3. When finishing the brickwork of the wall, take out the big
and small caps, and eliminate unwanted mask with a sharp
knife.
Note:
When building the wall, the product cannot be cast
and filled by cement or be squeezed.
3.
1338609-T01-B
1288193
110mm into
110mm
Air Hose
Inlet Hole
Drainage Hole
Big Cap
Big Cap
-9-
Air Hose Connector
Water Tank Bracket
Drainage Pipe
Small Cap
Long Screw
Tank Bracket
Mask
Small Cap
Advertisement
Table of Contents
