Table of Contents
Advertisement
2. K-20341T-PNE/K-75890T-PNE installation
2. K-20341T-PNE/K-75890T-PNE
1)
When tighten four locknuts on supporting board, adjust
to "OPEN" mark as shown.
1)
OPEN
2) Tighten four screws to "LOCK" mark after installing
supporting board as shown.
2)
3) Install the big flush air hose and small flush air hose to
the cover.
Put the lock on the cover directly on the
reversed lock on supporting board, then push the cover
and lock it. The installation shall begin from bottom to
top.
Note:
Cut the excessive parts of the air hose if
necessary.
3)
4) It is ready to use when connected to water supply after
installation.
Note:
Reserve access panel at front of the tank in
remote installation.
4)
1338609-T01-B
LOCK
Supporting Board
Connect to air hose
-13-
Faceplate
Lock
Supporting
Board
Full Flush
Button
Locknut
Fixing Lock
Supporting Board
Locknut
Faceplate
Half Flush Button
Advertisement
Table of Contents
