Table of Contents
Advertisement
During remote plate installation, 11~20mm thickness
is recommended for the wall of the pinch plate and at
least 70mm gap is reserved. Recommended
installation hole size of
plate installation.
70mm
+2
+2
297
X
157
mm
0
0
During remote installation of mask, 4 slots are needed
to be reserved so as to contain ribs on mask before
mounting mask onto wall. Drill 10mm holes through
air hose on the side of mask.
10mm
2) K-20341T-PNE/K-75890T-PNE access panel installation
2) K-20341T-PNE/K-75890T-PNE
A. Press from front
A.
a)
Keep cover but remove its central part, and then fix
mask onto cover with 4 self-tapping screws.
a)
b) Unplug air hose on flush valve side from air hose
connector and pull it out from the mask.
b)
Note:
This mask assembly needs to be purchased
separately. Part number: 1288193.
B. Remote plate installation and Remote installation of
mask
B.
During remote installation, fix the cover onto the tank
and pull the air hose to the panel. Reserve access
panel at front to ensure removal and installation of
cover.
1338609-T01-B
+2
+2
297
X
157
mm to remote
0
0
11~20mm
4
1288193
Pinch plate
Supporting
Board
Finished wall
Air hose
Fix Mask Onto Wall
Air hose
4 Ribs Depth 12,
Space reserved
4
12
71
Remove Central Part of Cover
Air Hose
-7-
11~20mm recommended
11~20mm
At least 70mm gap reserved
70mm
+2
297
0
+2
157
Finished
wall
Length X Width: 32 X 12
2 X 12
Space reserved
2 X 32
X
32 X 12,
205
2 X 25
Length X Width: 25 X 15
Space reserved
2 X 15
X
25 X 15,
311
Mask
Cover
Protective
Cover
Screw
Water Tank
Air Hose Connector
Cover
0
89
Advertisement
Table of Contents
