Table of Contents
Advertisement
A. Wash Filtration Net
Close corner valve first, then loosen and take out the
tighten nut, and wash the waste on filtration net with clean
water. Then reset the tighten nut to the original position.
Close
B. Adjust Inlet Valve
Hoist and reduce the water level in the tank by adjusting
the control pole. Turn the control pole counterclockwise to
lower down the floating box and reduce the water level of
the tank. Turn the control pole clockwise to hoist the
floating box and increase the water level in the tank
B.
TROUBLE SHOOTING PROCEDURES
TROUBLE SHOOTING PROCEDURES
Symptoms
No water fills in via inlet
valve
No flush when pressing
the full and half flush
button, pressing full flush
button results in half flush
effect and vise versa.
Too high or too low water
level
Leak of the toilet and
squat
Toilet swing
1338609-T01-B
Open
Corner Valve
Loosen Nut
Probable Causes
The inlet valve is closed
Floating box of inlet valve is blocked by tank wall
Floating box of inlet valve is block by waste
The adjusting rod of the inlet valve or the floating
box is wrapped by the air hose
The air hose is loose, bent or connected to its
apposite button
Water level of the inlet valve is not appropriate
The air hose is bent and blocked
Inappropriate adjustment of the overflow pipe
Hexagonal nut is loose
A.
Tighten Nut
Filtration Net
Open inlet valve
Adjust floating box to appropriate position
Wash the floating box with clean water
Arrange the hose correctly
Rearrange the air hose.
Readjust water level
Adjust the control pole to appropriate
position
Arrange the air hose correctly.
Tighten the hexagonal nut
-19-
Floating Box
Adjustment Switch
Recommended Action
Advertisement
Table of Contents
