Sony SAL35F14G Service Manual page 68

5) Search the position where the message "At Inf-Point" is displayed on the pop-up window by turning the lens to the infinity position.
6) Perform "4-7-1. Focus Brush Position Check" and "4-7-2. Focus Pattern Check".
7) After checked, tighten two screws loosened, and apply the adhesive bond (B-10) to the screws.
3. In case of error display in the Search Focus Adjustment Point
1) When the error message "Out of Point" is displayed and the NG display appear to the pop-up window, press the ENTER key to return
to the initial window, and perform "2. Checking Method"again.
4-7-4. Check/Write
1) Click [Write
[Select SB] window is displayed.
At this time, the current
2) Write the SB based on the error amount that was confirmed by the "4-6. FOCUSING ERROR AMOUNT CHECK".
Example)
When changing the focus to the front (Front focus): Select the left side of the button (current
When changing the focus to the rear (Rear focus):
3) Performs the "4-6. FOCUSING ERROR AMOUNT CHECK", and check that the error amount is smaller than the reference value.
If the error amount is larger than the reference value, perform [Write
becomes less than reference value.
SAL35F14G (1.4/35G) (35mm F1.4G)
SB
SB].
SB is highlighted.
(1)
To the front focus
Fig. 4-7-7
Fig. 4-7-8
[Enter] key.
Select the right side of the button (current
[Enter] key.
To the rear focus
Fig. 4-7-9
SB] again, and repeat steps 1) to 3) until the error amount
4-29
SB) that is highlighted and press the
SB) that is highlighted and press the
(5)