Sony SAL35F14G Service Manual page 25

Ver 1.2 2007.06
HELP15
Adhesive bond (B-10):
Grease (G-35):
Anti-diffusion agent (A-20): J-6082-611-A
Universal wrench:
Chip-A for Universal wrench: J-6082-609-1
Chip-B for Universal wrench: J-6082-609-2
Note:
Select the chip-A or chip-B for usage.
1. Apply the anti-diffusion agent (A-20) to the indicated portions of cam ring.
2. Apply the grease (G-35) to the cam ring, cam groove and them contact zone.
3. Attach the float ring so that the groove of cam ring places the bosses of float ring.
4. Apply the grease (G-35) to the indicated portions of cam ring holder.
5. Use the universal wrench, After tightening the cam ring holder, loosen it about 10 to 15mm from dead end, apply the adhesive bond
(B-10) to indicated portion.
Note:
After apply the adhesive bond (B-10), plese leave it for 6 hours or move. (The mountside is the under.)
6. Conform the movement of the cam ring.
Apply the anti-diffusion agent (A-20)
Apply the grease (G-35)
(6 locations of cam groove)
Apply the anti-diffusion agent (A-20)
Apply the grease (G-35)
Boss of float ring
Focus Operating Ring
SAL35F14G (1.4/35G) (35mm F1.4G)
J-6082-612-A
J-6082-621-A
J-6082-609-A
After confirming the movement,
apply the adhesive bond (B-10) in
width of 5 to 10mm to 2 locations.
Cam Ring
Groove
Fixed Barrel
Cam Ring Holder
Apply the grease (G-35) to holding
surface sides of cam ring holder.
Apply the anti-diffusion agent (A-20)
Apply the grease (G-35)
Cam Ring
Apply the grease
(G-35)
Fixed Barrel
Apply the adhesive bond (B-10)
(circumference of 2 locations,
width of 5 to 10mm)
Apply the grease (G-35)
(6 locations of cam groove)
Cam Ring
Cam Ring Holder
HELP