Sony SAL35F14G Service Manual page 67

4. In case of error display in the Focus Pattern Check (infinity position)
1) When the error display and the NG display appear on the pop-up window, perform "2. Checking Method" again so that setting the
lens to the infinity position can be done within 5 to 20 seconds.
• When the focus pattern error
• When the lens has elapsed 20 seconds without reaching the infinite end
2) Perform "2. Checking Method" again, repeat the inspection until "OK" appears on the pop-up window.
4-7-3. Focus Brush Position Adjustment (Search Focus Adjustment Point)
Note:
Perform this adjustment when an error occurs in the "4-7-1. Focus Brush Position Check" and "4-7-2. Focus Pattern Check".
Equipment
• Personal Computer
• Finished Inspection Jig II
• Lens Adjustment Program (RomCheckerSVerXXX.zip)
1. Preparations
1) Connected to equipment with checking lens. (Refer to Section 4-1-4.)
2) Start up the Lens Adjustment Program.
3) Click [Setup], and perform the initial setting. (Refer to Section 4-1-5.)
2. Checking Method
1) Set the focus position to infinity position.
2) Remove the hold sheet, confirm that can see the brush base plate.
3) Loosen two screws fixing the brush base plate.
Screw Screw Brush Base Plate
Fig. 4-7-6
4) Click the [Search Focus-Adj].
SAL35F14G (1.4/35G) (35mm F1.4G)
4-28