Sony SAL35F14G Service Manual page 66
1.4/35g; 35mm f1.4g
Hide thumbs
Also See for SAL35F14G:
- Service manual (78 pages) ,
- Brochure & specs (48 pages) ,
- Specifications (35 pages)
Advertisement
4-7-2. Focus Pattern Check (Focus Pattern)
Equipment
• Personal Computer
• Finished Inspection Jig II
• Lens Adjustment Program (RomCheckerSVerXXX.zip)
1. Preparations
1)
Connected to equipment with checking lens. (Refer to Section 4-1-4.)
2)
Start up the Lens Adjustment Program.
3)
Click [Setup], and perform the initial setting. (Refer to Section 4-1-5.)
2. Checking Method
1)
Click the [Focus Pattern].
2)
The Serial window appears. Input the lens serial number.
Note:
When [OK [Ent]] is clicked without inputting the serial number, the date executed is displayed on the completion window of
each item.
3)
The message "Move Focus to Inf. Then push [Enter] key." is displayed on the pop-up window. Set the focus to the infinity position
and press the ENTER key.
4)
The message "Move Focus to Near. Then push [Enter] key." is displayed on the pop-up window. Set the focus to the near position
and press the ENTER key.
5)
When the Near position check finishes normally, the message "Move Focus to Inf. Then push [Enter] key." is displayed on the pop-up
window. Set the focus to the infinity position and press the ENTER key.
6)
When the position check finishes normally, "OK" is displayed on the pop-up window, and press the ENTER key to return to the
initial window.
3. In case of error display in the Focus Pattern Check (near position)
1)
When the error display and the NG display appear to the pop-up window, press the ENTER key to return to the initial window, and
perform "2. Checking Method" again.
2)
Although the lens is positioned at the near position, if "NG" appears, confirm or perform the following.
• Perform "4-7-3. Focus Brush Position Check (Search Focus Adjustment Point)" again.
• Cleaning of flexible pattern or the brush.
• Replaceing the brush.
• Rotating operation error of the focus ring (rotation speed is not suitable at a regulated speed).
3)
Perform "2. Checking Method" again, repeat the inspection until "OK" appears on the pop-up window.
SAL35F14G (1.4/35G) (35mm F1.4G)
Fig. 4-7-4
Fig. 4-7-5
4-27
Advertisement
