Sony SAL35F14G Service Manual page 27

Ver 1.2 2007.06
HELP17
Adhesive bond (B-40):
Grease (G-115):
Anti-diffusion agent (A-20): J-6082-611-A
1. Apply the anti-diffusion agent (A-20) to the indicated portions of the torque ring A.
2. Apply the grease (G-115) to contact zone of the torque ring A, the float ring and the scissors lever block.
3. Attach the float ring and the scissors lever block to the torque ring A, tighten the screw temporarily.
Note:
When turning the float ring, to become shake is minimized and to become turn the float ring smoothly, do the adjustment of
the changing wick pin of scissors lever block.
4. Attach the torque ring B to torque ring A shown in the figure, apply the adhesive bond (B-40) to the screws and tighten them.
Apply the adhesive bond (B-40)
Torque Ring A
Apply the anti-diffusion
agent (A-20)
Apply the adhesive
bond (B-40)
Float RIng
Scissors Lever Block
Torque Ring B
5. Affix the friction Tape A to torque ring A shown in figure.
Friction Tape A
Torque Ring A
SAL35F14G (1.4/35G) (35mm F1.4G)
J-6082-614-A
J-6082-627-A
Apply the anti-diffusion agent (A-20)
Apply the adhesive bond (B-40)
Torque Ring A
Scissors
Lever Block
Scissors
Lever Block
Apply the grease (G-115)
Torque Ring A
Apply the anti-diffusion agent (A-20)
Charging Wick Pin
Torque Ring A
Affix to the edge side.
Edge side
Friction Tape A
Float RIng
HELP