Sony SAL35F14G Service Manual page 30

HELP20
Adhesive bond (LOCTITE 460) (Note)
Note:
Use adhesive bond (LOCTITE 460) or an equivalent article.
Do not use what becomes white after drying like quick-drying glue.
Apply the adhesive bond (LOCTITE 460) to the tip of mount index and install it to the outer barrel and G decoration ring.
Apply the adhesive bond (LOCTITE 460)
to the tip of mount index
HELP21
Adhesive bond (LOCTITE 460) (Note)
Note:
Use adhesive bond (LOCTITE 460) or an equivalent article.
Do not use what becomes white after drying like quick-drying glue.
Adhesive bond (B-10): J-6082-612-A
1. Apply a little amount of the adhesive bond (LOCTITE 460) to the indicated portions of focus hold button base.
2. Apply the adhesive bond (B-10) to the tip of one screw shown in figure and tighten the screw.
3. Check the "Focus Hold Button Check (Focus Hold Button)" in section "4-7. FINISHED ADJUSTMENT/INSPECTION".
Apply the adhesive bond (B-10)
Washer
Click Plate
SAL35F14G (1.4/35G) (35mm F1.4G)
Mount Index
Outer Barrel and G Decoration Ring
Apply the adhesive bond (LOCTITE 460)
Focus Hold Button Base
Focus Hold Button
Dust Proofing Tape
HELP