Sony SAL35F14G Service Manual page 65

4-7-1. Focus Brush Position Check (Focus Adjustment Point)
Equipment
• Personal Computer
• Finished Inspection Jig II
• Lens Adjustment Program (RomCheckerSVerXXX.zip)
1. Preparations
1) Connected to equipment with checking lens. (Refer to Section 4-1-4.)
2) Start up the Lens Adjustment Program.
3) Click [Setup], and perform the initial setting. (Refer to Section 4-1-5.)
2. Checking Method
1) Click the [Focus-Adj Point].
2) The Serial window appears. Input the lens serial number.
Note:
When [OK [Ent]] is clicked without inputting the serial number, the date executed is displayed on the completion window of
each item.
Fig. 4-7-2
3) The message "Move Focus to Near. Then push [Enter] key." is displayed on the pop-up window. Set the focus to the near position and
press the ENTER key.
4) When the Near position check finishes normally, the message "Move Focus to Inf. Then push [Enter] key." is displayed on the pop-up
window. Set the focus to the infinity position and press the ENTER key.
5) When the infinity position check finishes normally, "OK" is displayed on the pop-up window, and press the ENTER key to return to
the initial window.
3. In case of error display in the Focus Adjustment Point
1) When the error display and the NG display appear to the pop up window, press the ENTER key to return to the initial window, and
perform "2. Checking Method" again.
• In case of error at the near position in the Focus Adjustment Point
• In case of error at the infinity position in the Focus Adjustment Point
2) Although the lens is positioned at the near position or the infinity position, if "NG" appears, confirm or perform the following.
• Perform "4-7-3. Focus Brush Position Check (Search Focus Adjustment Point)" again.
• Cleaning of flexible pattern or the brush.
• Replaceing the brush.
3) Perform "2. Checking Method"again, repeat the inspection until "OK" appears on the pop-up window.
SAL35F14G (1.4/35G) (35mm F1.4G)
Fig. 4-7-3
4-26