Remote Access Configuration; Serial Port Mode - American Megatrends StorTrends 2104 User Manual

Section 2 Advanced Setup,

Remote Access Configuration

You can disable or enable the BIOS remote access feature here. The Optimal and Fail-
Safe default setting is Disabled.
Option Description
Disabled Set this value to prevent the BIOS from using Remote Access. This is the default Fail-Safe
setting.
Serial (ANSI) Set the value for this option to Serial to allow the system to use the remote access feature. The
remote access feature requires the use of the serial port connector located at the rear of the
StorTrends 2104 NAS server.

Serial Port Mode

Select the baud rate you want the serial port to use for console redirection. This option
only appears if Remote Access is set to Serial (ANSI).
Option Description
115200 8,n,1 Set this value to allow you to select 115200 as the baud rate (transmitted bits per second) of the
serial port. This is the default setting.
57600 8,n,1 Set this value to allow you to select 57600 as the baud rate (transmitted bits per second) of the
serial port.
19200 8,n,1 Set this value to allow you to select 19200 as the baud rate (transmitted bits per second) of the
serial port.
Continued
SYSTEM SETUP UTILITY
Advanced
Configure Remote Access type and parameters
Remote Access [Serial (ANSI)]
Serial Port Mode [115200 8,n,1]
v02.03 (C) Copyright 1985-2003, American Megatrends Inc.
Select remote
access type
Select Screen
Select Item
+ - Change Field
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit
serial port
Chapter Three : AMIBIOS Setup 41