Text Mode - American Megatrends StorTrends 2104 User Manual

StorTrends NAS Software Installation,

Text Mode

Use the following steps to install the StorTrends NAS Software into the StorTrends 2104
NAS server in Text Mode.
Step Action
1 Connect the following devices to your StorTrends 2104 NAS server:
•
a VGA or better resolution monitor
•
a USB or PS/2 keyboard
•
a USB CD-ROM drive
Note:
You can also opt to use an IDE CD-ROM drive by attaching an IDE CD-ROM drive to the IDE
connector on the hard disk drive tray in the third bay from the left. If you try to load from any
other bay, the installation can fail.
2 Connect the power cable to the StorTrends 2104 NAS server's power connector. Verify that the power
LED on the back of the chassis is lit green.
3 Connect the Ethernet cable into one of the two NIC connectors on the back of the StorTrends 2104 NAS
server.
4 Connect the other end of the Ethernet cable into a functioning Ethernet jack. Verify that the link LED on
the NIC connector is illuminated. If the LED is not illuminated, check to make sure that each end of the
Ethernet cable is seated properly in the NIC connector and the Ethernet jack.
5 Power on your StorTrends 2104 NAS server and insert the StorTrends NAS Software (Version 2.0) CD.
Allow your StorTrends 2104 NAS server to boot up off the StorTrends NAS Software CD.
Note:
The system BIOS must be set to boot from the CD-ROM first.
6 After your StorTrends 2104 NAS server boots up, you are prompted to install the StorTrends NAS
Software. Press the <ENTER> key to begin the installation.
StorTrends™ 2104 User's Guide
12
Continued
Welcome to AMI NAS Software
- To install AMI NAS Software, press the <ENTER> key.
boot: _
2.0!
Cont'd