Unpack And Inspect; Install Hard Disk Drives - American Megatrends StorTrends 2104 User Manual

Unpack and Inspect

Inspect the cardboard carton for obvious damage. If damaged, call 770-246-8645. Leave
the StorTrends 2104 NAS server in its original packing.
Your StorTrends 2104 NAS server ships with the following:
•
a StorTrends 2104 NAS server
•
one (1) Intel Pentium® 4 processor with a speed of 2.4 GHz (or higher frequency)
•
one (1) ECC 512 MB registered DDR PC-2100 SDRAM (or more memory)
•
a warranty and registration card
•
this StorTrends 2104 User's Guide (located on the StorTrends Driver and Manual
CD)
•
an American Megatrends StorTrends NAS 2.0 User's Guide (located on the
StorTrends NAS Software CD)
•
a StorTrends 2104 Quick Installation Guide
•
a StorTrends NAS Software CD (includes the software drivers and documentation)
•
a rack mounting kit
•
an external power cable

Install Hard Disk Drives

The StorTrends 2104 NAS server ships with no (0) ATA 100/133 hard disk drives.
Before you can use your NAS server, you must install at least one (1) hard disk drive into
the first hard drive bay located on the left hand side of the chassis.
Step Action
1 To access the hard disk drives, you must first remove the chassis front panel. To remove the chassis front
panel, push the front panel latches inward and then pull the panel straight out and away from the front of
the chassis.
StorTrends™ 2104 User's Guide
8
push both front bezel latches towards each
other to release the front bezel
make sure that the
security lock is not in
the locked position
Cont'd