Installation - Mechanical
Figure 20. Section split - indoor
Section
Ends of hubcaps
trim cap
fit unter lip on trim
Wall
Hubcap
Section split
Wall
Trim
Outdoor Roof - Single Span
1. Ensure shipping split sections are aligned and pulled
together properly.
2. Add a bead of caulk along the length of the roof seams.
Install the pre-cut J-cap over the seam and secure with
#14 sheet metal screws on 12-inch centers.
Figure 22. Outdoor roof assembly - single span
Roof split outdoor unit
3-in. x 1/8-in. neoprene gasket is
applied to metal joining strip. Apply
gasket to metal strip before installation.
22
Edge view
Hubcap
Roof
Trim
Section split
Roof
Add caulking before
installing J cap
Figure 21. Section split - outdoor
End of hubcap fits
under lip on trip
Hubcap
Section split
Note: Use a polyurethane or equivalent caulk. It may be
necessary to clamp the joint together or pre-drill to
prevent separation when drilling with screws.
3. Apply caulk to end of J-cap to seal thoroughly.
Joining cap
#10 x 1-in. self-tapping screw
4-in. x 1/4-in. gasket
Roof panel
section split
2 3/4-in. wide joining strip
#8 x 1-in. Phillips zip screw
Edge view
Trim
Trim
CLCH-SVX010A-EN