Emerson Rosemount 702 Quick Start Manual page 8

Quick Start Guide
Procedure
1. Install the switch according to standard installation practices making sure
to use thread sealant on all connections.
2. Attach the Rosemount 702 Transmitter housing to the switch using the
threaded conduit entry.
3. Attach the switch wiring to the terminals as indicated on the wiring
diagram (see
4. Connect the Black Power Module.
Note
Wireless devices should be powered up in order of proximity from the
Smart Wireless Gateway, beginning with the closest device to the
Gateway. This will result in a simpler and faster network installation.
5. Close the housing cover and tighten to safety specification. Always
ensure a proper seal so the metal touches metal, but do not over tighten.
6. Position antenna vertically, either straight up or straight down. The
antenna should be approximately 3 ft. (0.91 m) from any large structures
or buildings, to allow clear communication to other devices.
8
Chapter 5).
Rosemount 702 Wireless Discrete Transmitter
April 2018