Video Commissioning; Microphone And Loudspeaker Volume Setup; Nameplate Labelling - TCS VPES Series Product Information

Front-door station series with video for surface-mount

Hide thumbs

Table Of Contents

Table of Contents

First fully install the system, then connect power!

• V1 and V2 must never - not even temporarily - be connected to the P, a or b wires.

Such a connection would destroy the device.

• When connecting the video wires V1 (+) and V2 (-) the polarity must be observed.

If the image is distorted after commissioning, switch off the device and replace the

wires for the video signal.

Microphone and loudspeaker volume setup

For adjustments use the small screwdriver supplied!

The volumes have been set to an average value

at factory. A modification may not always be

necessary.

When adjusting please note:

The amplification of loudspeaker and microphone

cannot be set independently from each other.

Too great volume will cause a feedback effect

(whistling).

The templates are available on our website

www.tcs-germany.com

System and technology basics\ Product installa-

tion and use \ labelling of the nameplate

1. Enter the desired name into the template.

2. Print the name plate on the special film* and

cut it to size.

3. Insert the cut plates from the side into the po-

ckets on the name plate glass.

We recommend to print the name plates on a durable special

film. The film can be ordered directly from TCS: Writable poly-

ester film for name plates DIN A4.

TCS TürControlSysteme AG • Geschwister-Scholl-Str. 7 • 39307 Genthin

Phone.: +49 39 33 / 87 99 10 • Fax: +49 39 33 / 87 99 11 • www.tcs-germany.com