Table of Contents
Advertisement
Replacing the EEPROM memory
All programmed data, like serial numbers and parameters, are stored in the EEPROM. If
the front-door station requires replacement, the EEPROM board can be removed from the
programmed front-door station and inserted into the new front-door station of identical de-
sign.
• Open the case.
• Pull the small PCB off the electronic board.
• Plug the EEPROM board onto the pins in the new un-programmed front-door station.
Take care that all four poles of the plug are inserted into the jack of the small PCB and
that the component side is visible.
• After replacement all programming is available again.
Avoid water entering the device!
!
Do not use any aggressive or abrasive cleaning agents!
Clean the device using a dry or slightly moist cloth.
More persistent dirt can be removed using a mild household cleaner.
TCS TürControlSysteme AG • Geschwister-Scholl-Str. 7 • 39307 Genthin
Phone.: +49 39 33 / 87 99 10 • Fax: +49 39 33 / 87 99 11 • www.tcs-germany.com
Cleaning
Contact your local sales representative or
www.tcs-germany.com
17
Repair
Service
Subject to change without notice.
PI_GB_VPES_VPDS_Art0016079_2v0.doc mi
05/2006
Advertisement
Table of Contents
