Station Mounting - Siemens 353 User Manual

UM353-1B
2.84
(72)
Case
Flange
5.67
(144)

7.3.3 Station Mounting

A straight slot screwdriver with at least a 10" (254 mm) shank is needed to tighten the two mounting clip screws.
1. Locate the supplied Mounting Clip Kit. It contains two mounting clips and two 8-32 x 1" fillister head screws.
Thread the mounting screws into the mounting clips. See Figure 7-4.
2. From in front of the panel, insert the controller case into the panel cutout.
3. Slightly rotate the top mounting clip to fit it into the case cutout. Then straighten the clip and partially tighten
the mounting screw. Insert, straighten and partially tighten the bottom clip.
4. Square the controller with the panel.
5. Alternately tighten top and bottom mounting clip screws until the controller is secured to the panel. Do not
over tighten and distort the case.
April 2012
11.25
(285.8)
TOP VIEW
Mounting Clip
1.18
(30)
SIDE VIEW
0.32
Max.
(0.8)
Figure 7-3 Siemens 353 Dimensions
Side View
Bottom View
Figure 7-4 Case Mounting Clip
2.67
(67.8)
Dimensions in inches (millimeters)
5.42 6.3
(137.7) (160)
Insert clip as shown
and straighten
X03103S0
Installation
7-5