Table of Contents
Advertisement
DIAL LINE OPERATION
This section explains how to configure the ISU 2x64 when using
ISDN Basic Rate switched service. Figure 6-3 illustrates the entire
menu tree.
The following are step-by-step procedures for configuring the
unit for dial line operation, switch protocol, call type, terminal ID,
dial options, auto answer, answer tone, connect timeout, call
screening, and SBus termination.
To dial calls over the ISDN, the unit must be configured for Dial
Line. The menu path to select Dial Line operation is shown in Fig-
ure 6-1.
3=CONFIG
When using a VT 100 terminal, press Ctrl + C to access the Con-
figuration screen, then set the Line type option to Dial Line. The
screen appears as shown in Figure 6-2.
61200051L1-1D
1=Netw. options
2=DTE options
3=Protocol
4=Quick setup
5=Security
6=Remote Config
ISU 2x64 Dual Port ISDN Service Unit User Manual
Chapter 6
Configuration
1=Dial Line
2=Leased Line
Figure 6-1
Dial Line Menu Tree
27
Advertisement
Table of Contents
