Dial Options, Rs-366 Menu Tree - ADTRAN 1200051L1 User Manual

RS-366 parallel dialing port, configure the unit for RS-366 dialing.
(See Figure 6-4.) This enables the RS-366 port on the rear of the
unit. Whenever this dialing mode is enabled, data terminal ready
(DTR) must be active before a call is placed. The call may be dis-
connected by dropping DTR, or from the front panel by selecting
the # (pound) key to go directly to the Dial menu and selecting
1=Hang up line, then Enter.
DTE RS-366 dialers can end their string of dialed numbers in two
different ways. The end of number (EON) alerts the ISU 2x64
that the entire number has been sent. Another method is to sim-
ply stop sending numbers and allow the ISU 2x64 to time out,
then dial the number. The ISU 2x64 supports both methods of
dialed number terminations. The following options allow the
dialed number termination to be fine-tuned:
1=Netw. options
3=CONFIG 2=DTE options
3=Protocol
4=Quick setup
5=Security
6=Remote Config
The ISU 2x64 assumes the dial string is fully entered if more than
1 sec or EON:
one second elapses since the last digit was keyed, or the unit
receives the EON command.
The ISU 2x64 assumes the dial string is fully entered if more than
2 sec or EON:
two seconds elapse since the last digit was keyed, or the unit
receives the EON command.
The ISU 2x64 assumes the dial string is fully entered if more than
5 sec or EON (def):
five seconds elapse since the last digit was keyed, or the unit
receives the EON command. This is the factory default setting.
The ISU 2x64 assumes the dial string is fully entered if more than
10 sec or EON:
10 seconds elapse since the last digit was keyed, or the unit
receives the EON command.
61200051L1-1D
1=Switch protocl
2=Call type
1=Dial Line 3=Terminal ID
2=Leased Line 4=Busy Out
5=Dial options
6=Auto answer
7=Answer tone
8=Connect Timout
9=Call Screening
10=SBus Terminati
ISU 2x64 Dual Port ISDN Service Unit User Manual
Chapter 6. Configuration
1=1 sec or EON
2=2 sec or EON
1=Front Panel
3=5 sec(default)
2=RS-366
4=10 sec or EON
3=AT commands
5=20 sec or EON
4=V.25
6=Wait for EON
5=Disabled
Figure 6-4

Dial Options, RS-366 Menu Tree

35