Table of Contents
Advertisement
Appendix D: S-Register List
S6.........DTR DIAL DELAY
S7.........CONNECT TIME
S9 .........CLEAR CHAN DELAY The value multiplied by eight determines the number
S10 .......DISABLE REMOTE
CONFIG
S12 .......ESCAPE TIME
S14 .......MISC BITS
S15.........ASYNC BONDING REV Determines the revision level Bonding negotiates
110
Delay time in minutes between consecutive outgoing
calls when DTR is set for Dial #0 if on option.
Determines how long the ISU 2x64 waits for an out-
going call to be answered.
15 = 15 seconds
30 = 30 seconds (default)
60 = 1 minute
120 = 2 minutes
240 = 4 minutes
of bytes between receive data and transmit data.
Disables the two-second delay at the beginning of
each incoming call that scans for remote configuration
data. FALLBACK protocol cannot be used when this option
is set!
0 = Remote Config enabled
1 = Remote Config disabled
Determines the delay required immediately before
and after entering the escape command for the ISU
2x64 to recognize and execute the command.
Range = 0 to 127 (default = 1 second)
Miscellaneous bits (bit 8 is most significant bit) .
Bit 2 = 1:enables on screen echo of AT commands.
Bit 2 = 0: disables on screen echo of AT commands.
Bit 3 = 0: enables AT responses from the ISU 2x64.
Bit 3 = 1: disables AT responses from the ISU 2x64.
Bit 4 = 1: enables AT responses to be displayed
in text form.
Bit 4 = 0: enables AT responses to be displayed in nu-
meric form.
for asynchronous connections.
0 = ADTRAN orginal Async. Bonding
1 = Multivendor Async. Bonding (default)
ISU 2x64 Dual Port ISDN Service Unit User Manual
61200051L1-1D
Advertisement
Table of Contents
