Installing The Compact Processor; Turning The System On/Off; Turning On - Sony PCS-1500 Service Manual

Preparing the System
When using a Sony TV monitor
The TV monitor can be operated from the Remote
Commander.
For details on operating the Remote Commander, see "To
operate a Sony TV monitor" on page 94.
To adjust the TV monitor screen
Use the controls on the TV monitor to adjust the screen
(picture, hue, contrast, brightness, and sharpness).
For details on adjusting the screen, refer to the operating
instructions supplied with the TV monitor.
Note
Do not activate the surround function of the TV monitor. This
causes strange sounds since the echo canceler on the Compact
Processor will not function properly.

Installing the Compact Processor

When you install the Compact Processor, use the supplied
Velcro (long). This will prevent the Compact Processor from
falling down.
1
Stick one side of the supplied Velcro (long) to the bottom
of the Compact Processor.
2
Stick the other side of the Velcro to the top of the TV
monitor.
3
Attach the Compact Processor and the TV monitor by
securing the Velcro.
18
Chapter 1 Preparation

Turning the System On/Off

This section describes how to turn on and off the Compact
Processor.
Note
Set the CONF/DOC/TV selector on the Remote Commander to
"CONF" when operating the Compact Processor.

Turning On

The following describes how to turn on the Compact Processor.
1
Make sure the TV monitor is on standby.
For details on how to set the TV monitor into a standby
state, refer to the operating instructions supplied with the
TV monitor.
2
Turn on the power of any other equipment to be used
during the meeting.
3
Set the POWER switch on the rear of the Compact
Processor to on.
Soon, the Compact Processor and the TV monitor are
turned on.
The POWER lamps (green) on the camera and the
Compact Processor light up, and the self-diagnostic starts.
The picture shot by the local camera appears on the
monitor screen after the self-diagnostic is completed.
Rear
MIC AUDIO VIDEO
IN
(PLUG IN POWER) IN
AUX
1
DC12V T.120 2 AUX1
POWER
OUT OUT
AUX IR OUT
2 MONITOR
POWER switch
Front
ISDN A
POWER lamps
19
Chapter 1 Preparation