Sony PCS-1500 Service Manual page 53

Location and Function of Parts and Controls
Main unit (rear)
MIC AUDIO
(PLUG IN POWER)
IN
1
DC12V T.120
POWER
OUT
2
1 2 3 4 5 6 7 8
1 POWER switch 5 AUDIO IN jack (phono jack)
Connect to the audio output jack of
Switch the Compact Processor to on.
the external equipment.
2 DC 12V IN jack
6 AUDIO OUT jack (phono jack)
Connect the supplied PCS-AC15 AC
Connect to the audio input jack of the
adaptor to this jack.
TV monitor.
3 T.120 connector (D-sub 9-pin,
7 VIDEO AUX OUT jack (phono
male)
jack)
Connect an RS-232C device for data
Connect to the video input jack of the
input/output.
external equipment.
4 MIC1/MIC2 jacks/PLUG IN
8 VIDEO MONITOR OUT jack
POWER (phono jack)
(mini DIN 4-pin)
Connect the optional PCS-A300
Connect to the video input jack of the
Microphone(s) to these jacks. These
provide the power supply to the TV monitor.
microphone(s) connected to these
jacks.
88
Appendix
!¢
!£
!™ !¡
VIDEO
IN
AUX
2
AUX1
ISDN A
OUT
AUX IR OUT
MONITOR
9 0
9 IR OUT jack (minijack)
Connect the supplied IR repeater to
this jack.
0 ISDN A jack (8-pin modular)
Connect the ISDN line to this jack
using the ISDN modular cable.
!¡ Interface board slot
Install the optional board into this slot.
!™ VIDEO IN AUX 1 jack (mini
DIN 4-pin)
Connect to the video output jack of
the external equipment.
!£ VIDEO IN AUX 2 jack
(phonojack)
Connect to the video output jack of
the external equipment.
!¢ Camera screws
Loosen these screws to detach the
camera from the main unit.
Note
Tighten the camera screws firmly. If
the screws are loose, the camera may
fall down, and it causes personal
injury.
89
Appendix