Removal* Installation - Toyota 30 Series Manual

REMOVAL* INSTALLATION

Removal Procedure
Set the mast vertical and fully lower the fork.
1
Disconnect the chain. [Point 11
2
3 Remove the chain wheel. [Point 21
Remove the lift bracket. (For lift bracket removal, raise the inner mast until it comes off from the lift
4
bracket, and slowly run the vehicle backward to depart from the lift bracket.)
Remove the toe board.
5
Disconnect the overflow hose and high pressure hose. (Before hose disconnection, fully lower the
6
inner mast, operate the lift lever several times to release the residual pressure in the lift cylinder.)
Slightly hoist the mast.
7
Remove the mast support cap.
8
Remove the tilt cylinder front pin. [Point
9
Remove the mast ASSY.
10
T
=