Steering Knuckle; Removalinstallation - Toyota 30 Series Manual

STEERING KNUCKLE

REMOVAL-INSTALLATION
Removal Procedure
1 Jack up the vehicle.
2 Remove the hub cap. [Point 11
3 Remove the castle nut and claw washer. [Point 21
Remove the outer bearing and rear wheel. [Point 3 1
4
Remove the bearing outer race from the rear wheel. [Point
5
Remove the inner bearing roller and oil seal. [Point
6
Disconnect the tie rod (on the knuckle side).
7
Remove the king pin cover.
8
Remove the king pin lock bolt and king pin. [Point 61
9
10 Remove the thrust bearing, spacer and steering knuckle.
11 Remove the king pin oil seal and needle roller bearing. [Point 71
Installation Procedure
The installation procedure is the reverse of the removal procedure.
Note:
After installation, add MP grease through grease fittings.
T
=