Toyota 30 Series Manual page 45

rnrn
rnrn
4
(0.1 6 in)
Press-fitting direction
Installation:
Measure the steering knuckle starting force.
1. Temporarily install the king pin and king pin lock bolt.
Select the spacer so as to minimize vertical looseness
of the knuckle, and install it on top of the thrust bearing.
2. Set a spring scale at the tip end of the knuckle spindle,
and measure the starting force.
N
Standard: 19.3
3. If the standard is exceeded, check the king pin for bend,
the needle bearing for damage and axle beam for defor-
mation.
Spacer thickness:3.0,3.5,4.0 and 4.5
Tighten the lock nut for the king pin lock bolt.
4.
[Point 71
Removal:
Remove the king pin oil seal and needle roller bearing.
and oil seal.
2. Use the SST and remove the needle roller bearing.
SST 09950-6001 0
09950-7001 0
Installation:
Install the needle roller bearing and king pin oil seal.
Check the needle roller bearing press-fitting surface,
pressing direction and installation depth.
SST 09950-6001 0 ---
09950-7001 0 ---
2. Install the dust seal.
3. Use the SST and install the oil seal.
SST 09950-6001 0 ---
09950-7001 0 ---
(2.0 kgf) [4.4 Ibf] or less
mm
--- @
---