REAR WHEEL ALIGNMENT
Toe-in Inspection
Check to see that dimensions Ar and A ! of the rear axle cylinder are equal.
Measure the toe-in (Bf - Br).
2.
Standard: 0
mm (0
4
Punch mark on plate side
Punch mark on cylinder end pin side
0.16 in)
Toe-in Adjustment
equal.
2. Align the punch mark on the cylinder end pin (eccentric pin)
with the punch mark on the plate on the front side for both
the LH and RH sides.
Measure and adjust the toe-in (Bf
3.
Standard: 0
If the standard is not satisfied, make adjustment by the cyl-
inder end pin in the range where the difference between Rt
and Rr is within 0
Measure Rt and Rr, and adjust the cylinder end pin on
the smaller side toward IN.
(2) When measured value < 4 mm (0.1 6 in):
Measure Rt and Rr, and adjust the cylinder end pin on
the greater side toward OUT.
Note:
If Rt equals to Rr, adjust the same amount on the LH
and RH sides.
If the standard is not attained by adjustment on one
side, make adjustment also on the other side.
4. Install the plate. The plate can be installed with either face
5.
they do not come into contact with the vehicle body.
-
Br).
mm (0
4
0.16 in)
3 mm (0.1 2 in).
mm (0.1 6 in):