Toyota 30 Series Manual page 57

REMOVAL. INSTALLATION (WILI FT BRACKET)
Removal Procedure
1 Set the mast vertical.
Remove the forks.
2
3 Remove the toe board.
Disconnect the overflow hose and high pressure hose. (Before hose disconnection, fully lower the
4
inner mast and operate the lift lever several times to release the residual pressure from the lift cylin-
der.)
5 Slightly hoist the mast.
Remove the mast support cap.
6
7 Remove the tilt cylinder front pin. [Point I]
Remove the mast ASSY W/lift bracket.
8
Installation Procedure
The installation procedure is the reverse of the removal procedure.
T
=