Toyota 30 Series Manual page 21

Reassembly:
Adjust the drive pinion bearing starting torque.
fied torque.
2. Set a torque wrench on the lock nut, and measure the start-
ing torque.
Starting torque:
10.79
(1 10
3. If the starting torque does not satisfy the standard make
adjustment by changing the shim thickness.
Shim thickness:
0.03.0.1 0.0.1 5.0.35 and 0.45 mm
(0.001 2~0.0039~0.0059~0.0138
[Point 71
Disassembly:
SST 09950-4001 1
SST
Reassembly:
Use the SST and install the pilot bearing.
SST 09608-04031
Check the installed direction.
[Point 81
Disassembly:
SST 09420-23000-71
13.24 N-m
135 kg-cm)
-
9.77 ft-lb]
and 0.01 77 in)