Software; Additional Information - 3Com EtherLink 3C529 User Manual

NOTE: When you first install the adapter and power up
the computer, the LED will be lit, but the link beat is
inactive. For the link beat to be active (enabled), you
need to have run the Group 3 test or have loaded the
network drivers.
If you are experiencing any problems, first make sure that
your hub complies with the 10BASE-T specifications.
Then check the LED.
If the LED is on, the link beat is working.
If the LED is off, the link beat has not been established
or there is a problem with the connection between the
adapter and the hub.
If the LED is blinking, the polarity is reversed.

Software

If you have installed the adapter correctly and you still
experience problems, check the software.
Make sure that you have configured your computer for
the adapter. Refer to Chapter 2.
Make sure that you have installed the correct drivers for
the network operating system you are running (refer to
Chapter 5).

Additional Information

For any problems not discussed in this chapter, refer to
Appendix D, "Technical Support," for information on
3Com's on-line technical services. 3ComFacts
technical tips and product information. Ask3Com
CardBoard
tips, and product information.
SM
provide software updates, drivers, technical
Troubleshooting 6-15
SM
provides
SM
and