Appendix C Error Messages - 3Com EtherLink 3C529 User Manual

Error Messages C-1
Appendix C
Error Messages
This appendix lists in alphabetical order the EtherDisk diskette on-
line error messages. The text of each error message suggests
possible causes of the error condition and gives the appropriate
remedy in most cases. If error conditions persist, refer to Chapter 6,
"Troubleshooting."
A diagnostic test name was found in the configuration file at line x.
Only configuration parameter variables are allowed.
A network driver is installed. Start the computer with a
standard DOS diskette with no network drivers or TSRs, and
run the Configuration and Diagnostic Program again.
A syntax error was found in the configuration file at line x.
Adapter failed during Echo Exchange test. Try the test again.
If the failure persists, swap with a known good EtherLink III,
and try again.
Adapter failed while transmitting the request to locate the echo
server. This problem can be caused by either a cabling problem
or an adapter failure.
Adapter failed while trying to read the adapter configuration
stored on the adapter. Save a new configuration on the adapter.
If the problem persists, swap with a known good EtherLink III,
and try again.