3Com EtherLink 3C529 User Manual page 5

Parallel tasking 16/32-bit micro channel adapters
Table of Contents

Advertisement

FCC Class B Certification
3Com Corporation
Model Nos: 3C529 and 3C529-TP
FCC ID: DF67CC3C529
FCC ID: DF67CC3C529-TP
Made in the U.S.A.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)
this device may not cause harmful interference, and
(2)
this device must accept any interference received, including interference
that may cause undesired operation.
WARNING: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules, and
the Canadian Department of Communications Equipment Standards entitled,
"Digital Apparatus," ICES-003. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from the one
which the receiver is connected to.
Consult the dealer or an experienced radio/TV technician for help.
The user may find the following booklet prepared by the Federal
Communications Commission helpful:
The Interference Handbook
This booklet is available from the U.S. Government Printing Office,
Washington, D.C. 20402. Stock No. 004-000-00345-4.
NOTE: In order to maintain compliance with the limits of a Class B digital
device, 3Com requires that you use quality interface cables when connecting to
this device. Changes or modifications not expressly approved by 3Com could
void the user's authority to operate this equipment. Refer to the manual for
specifications on cabling types.
v

Advertisement

Table of Contents
loading

This manual is also suitable for:

Etherlink iii

Table of Contents