3Com EtherLink 3C529 User Manual page 79

A-8 Using the Configuration and Diagnostic Program
To configure and test the 3C529 adapter from the
command line, follow these steps:
1. Exit the Configuration and Diagnostic Program.
2. At the system prompt for the drive containing the
Configuration and Diagnostic Program, type:
3C5X9CFG [command keyword] [parameter list]
You can get help information for specific commands
such as RUN by typing HELP, then the command. For
example, at the system prompt for the drive containing
the Configuration and Diagnostic Program, type the
following and press [Enter]:
3C5X9CFG HELP RUN
NOTE: If this computer is an operating server, notify all
users of the server to save their work and log out from
the network. The Configuration and Diagnostic
Program disrupts the normal operation of servers and
workstations, so work that is not saved may be lost.
To avoid interference from other running programs,
power down the server, and reboot with a DOS-only
diskette.