3Com EtherLink 3C529 User Manual page 84

C-2 Error Messages
Either there is no boot PROM installed on the adapter or the
selected boot PROM base address is being used by another
device or software program installed by the computer. Do you
want to save the configuration anyway?
The adapter's I/O base address, interrupt request level, and
transceiver type have been successfully selected with Auto
Configure. For your new settings to take effect, save the settings,
exit, and reboot the computer.
The ConfigPort value xxxxx on the command line is not supported.
Valid settings are 100–1E0, in increments of 10. Please try again.
The selected EtherLink III can only be configured while in test
mode. The diagnostic tests cannot be run from this mode.
The selected interrupt request level is being used by another
device installed in the computer. Do you want to save the
configuration anyway?
The selected I/O base address is being used by another device
installed in the computer. Do you want to save the configuration
anyway?
The value xxxxx at line x in the configuration file is not supported.
Check the EtherLink III Adapter Guide for supported option
settings.
The value xxxxx on the command line is not supported. Check
the EtherLink III Adapter Guide for supported option settings.