Installing The Services Gateway; Installing The Srx550 Services Gateway In A Rack - Juniper SRX550 Hardware Manual

CHAPTER 15

Installing the Services Gateway

IN THIS CHAPTER

Installing the SRX550 Services Gateway in a Rack | 69

Installing an AC Power Supply on the SRX550 Services Gateway | 72
Installing a DC Power Supply on the SRX550 Services Gateway | 73
Installing the SRX550 Services Gateway in a Rack
You can front-mount the SRX550 Services Gateway in a rack. Many types of racks are acceptable, including
four-post (telco) racks, enclosed cabinets, and open-frame racks.
NOTE: If you are installing multiple devices in one rack, install the lowest one first and proceed
upward in the rack.
To install the services gateway in a rack:
1. Position a mounting bracket on each side of the chassis.
2. Use a Phillips (+) screwdriver, number 2 to install the screws that secure the mounting brackets to the
chassis. Use either the front mount position, as shown in
position as shown in Figure 15 on page 70.
Figure 14 on page 70, or the center mount
69